Prerequisites

Before you begin to install, configure, and use the Abatron BDI2000 Debugger, you'll need to verify that you have the following required hardware and software:

• Hardware requirements:
  
  • Abatron BDI2000 JTAG device
  • an appropriate JTAG debug cable for your target architecture
  • an Ethernet cable — a debug cable that connects the Abatron Debug Module to the debug interface on your target and it's suitable for your specific target architecture
  • a switch to your local network

  For the list of supported target boards for Abatron, see the Abatron website at:

  www.abatron.ch/products/debugger-support/gnu-support.xml

• Software requirements:
  
  • Abatron BDI2000 Firmware appropriate for your target architecture
  • QNX Momentics IDE version 4.5 or higher

The following Abatron configuration files, register definitions, and supporting documentation files are also available after you log on to Foundry27 at:

http://community.qnx.com/sf/frs/do/viewRelease/projects. internal_toolsfrs.jtag_utilities.abatron_configuration_files

http://community.qnx.com/sf/frs/do/viewRelease/projects.internal_tools/frs. jtag_utilities.abatron_configuration_files

• 83xx.rar
• 85xx.rar
• PPC4xx.rar

Support | Community