Purpose
Increases a
file system's contiguous free space.
Syntax
defragfs [ -q | -r | -s] { Device | FileSystem }
Description
The defragfs command increases a file system's contiguous free space
by reorganizing allocations to be contiguous rather than scattered
across the disk. The file system to be defragmented can be specified
with the Device variable, which is the path name of the logical
volume (for example, /dev/hd4). It can also be specified with
the FileSystem variable, which is the mount point in the /etc/filesystems file.
The defragfs command is intended for fragmented and compressed file systems.
However, you can use the defragfs command to increase contiguous
free space in nonfragmented file systems.
You must mount the file system read-write for this command to run
successfully. Using the -q flag, the -r flag or the -s flag generates a fragmentation report. These flags do not
alter the file system.
The defragfs command is slow
against a JFS2 file system with a snapshot due to the amount of data
that must be copied into snapshot storage object. The defragfs command issues a warning message if there are snapshots. The snapshot command can be used to delete the snapshots and then
used again to create a new snapshot after the defragfs command
completes.
Flags
| Item |
Description |
|---|
| -q |
Reports the current state of the file system. |
| -r |
Reports the current state of the file system and the state
that would result if the defragfs command is run without either
the -q, -r or -s flag. |
| -s |
Reports the fragmentation in the file system.
This option causes defragfs to pass through meta data in the
file system which may result in degraded performance. |
Output
On a JFS filesystem, the definitions
for the messages reported by the defragfs command are as follows:
- Number of free fragments
- The number of free fragments in the file system.
- Number of allocated fragments
- The number of allocated fragments in the file system.
- Number of free spaces shorter than a block
- The number of free spaces within the file system that are shorter
than a block. A free space is a set of contiguous fragments that
are not allocated.
- Number of free fragments in short free spaces
- The total number of fragments in all the short free spaces. A
short free space is one that is shorter than a block.
- Number of fragments moved
- The total number of fragments moved.
- Number of logical blocks moved
- The total number of logical blocks moved.
- Number of allocation attempts
- The number of times free fragments were reallocated.
- Number of exact matches
- The number of times the fragments that are moved would fit exactly
in some free space.
- Total number of fragments
- The total number of fragments in the file system.
- Number of fragments that may be migrated
- The number of fragments that may be moved during defragmentation.
- FileSystem filesystem is n percent fragmented
- Shows to what extent the file system is fragmented in percentage.
On a JFS2 filesystem the definitions for the
messages reported by the defragfs command are as follows:
- Total allocation groups
- The number of allocation groups in the file system. Allocation
groups divide the space on a file system into chunks. Allocation
groups allow JFS2 resource allocation policies to use well known
methods for achieving good I/O performance.
- Allocation groups defragmented
- The number of allocation groups that were defragmented.
- Allocation groups skipped - entirely free
- The number of allocation groups that were skipped because they
were entirely free.
- Allocation groups skipped - too few free blocks
- The number of allocation groups that were skipped because there
were too few free blocks in them for reallocation.
- Allocation groups skipped - contains a large contiguous free space
- The number of allocation groups that were skipped because they
contained a large contiguous free space which is not worth defragmenting.
- Allocation groups are candidates for defragmenting
- The number of allocation groups that are fit for defragmenting.
- Average number of free runs in candidate allocation groups
- The average number of free runs per allocation group, for allocation
groups that are found fit for defragmentation. A free run is a contiguous
set of blocks which are not allocated.
- Total number of blocks
- The total number of blocks in the file system.
- Number of blocks that may be migrated
- The number of blocks that may be moved during defragmentation.
- FileSystem filesystem is n percent fragmented
- Shows to what extent the file system is fragmented in percentage.
Security
Attention RBAC users and Trusted AIX users: This
command can perform privileged operations. Only privileged users can
run privileged operations. For more information about authorizations
and privileges, see Privileged Command Database in AIX® Version 7.1 Security. For a list
of privileges and the authorizations associated with this command,
see the lssecattr command or the getcmdattr subcommand.
Examples
- To defragment the /data1 file system located on the /dev/lv00 logical volume,
enter:
- To defragment the /data1 file system by specifying its mount point, enter:
- To generate a report
on the /data1 file system that indicates its current status
as well as its status after being defragmented, enter:
defragfs -r /data1
- To generate a report on the fragmentation in the /data1 file system, enter:
defragfs -s /data1
Files
| Item |
Description |
|---|
| /etc/filesystems |
Lists the known file systems and defines their characteristics. |